China's drying equipment will gradually embark on the road of independent innovation
The low level of automatization of domestically produced drying equipment and the backwardness of control means are common problems. As far as the current level of automation is concerned, it is not difficult to solve the control problem in the drying equipment, but what is lacking most is the problem of the reasonable combination of the automatic control technology and the drying equipment. As mentioned earlier, different materials have different requirements for dryers. Similarly, there are major differences in the requirements for control methods for different materials. The role of automatic control in the dryer is well-known, but its one-time investment is also the issue that people are most concerned about. Sometimes the investment in control equipment even exceeds the investment in the mechanical part of the dryer. It is also the subject that research should be carried out to determine a reasonable control plan for dryers and drying process requirements and to determine appropriate control measures for specific drying projects.
In addition, it should also pay attention to the magnification of drying equipment . The enlargement involves disciplines such as fluid mechanics, mechanics, thermodynamics, heat transfer, materials science, dust removal, corrosion protection, electrical appliances, and control. It is very likely that some problems will arise during the amplification process. Therefore, the amplification of the drying device is by no means a simple geometrical enlargement. In this respect, it largely depends on the experience of industrialization, the mastery of the physical properties of materials and the understanding of drying equipment. The phenomena that may occur during the enlargement process should be predicted rationally and objectively, and corresponding solutions can be proposed. The so-called research amplification effect is to grasp the drying theory and drying technology while paying attention to accumulating practical experience and summing up lessons.
Hi-Carbon Steel Cut Wire Shot, also named Reinforced Steel Shot, has a great effect on die casting parts which has a high hardness because Longlived Hi-Carbon Steel Cut Wire Shot also have high hardness while other Metal Abrasive can not meet.
Longlived Hi-Carbon Steel Cut Wire Shot is made from high quality hi-carbon steel wire by drawing, cutting and rounding. Its chemical composition is : Si:0.10-0.30%, Mn:0.40-1.20%, C:0.45-0.85%, S≦0.04%, P≦ 0.04%. Longlived Hi-Carbon Steel Cut Wire Shot is producted strictly in accordance with German standard VDFI8001/2009 and American standard SAEJ441,AMS2431. There are four types of hardness of Longlived Hi-Carbon Steel Cut Wire Shot and they are HRC 45-50, HRC 50-55, HRC 55-60 and HRC 58-63. As the development of advance technology of Longlived Metal, we have five shapes and they are as cut, G1, G2, G3 and even G4 condition, which could meet most requirement of clients. In addition, the size of Longlived Metal is from 0.25mm-2.5mm and size also could be customized if need. Longlived Hi-Carbon Steel Cut Wire Shot has a great fatigue life and it could be recycled from 3,500 times to 9,000 times. It could not only save cost but also make shot blasting faster and cleaner.
Hi-Carbon Steel Cut Wire Shot,High-Carbon Steel Cut Wire Shot Peening,High-Carbon Steel Cut Wire Shot Blasting,High-Carbon Steel Cut Wire Shot Distributor
Longlived Metal Products Co ., Ltd , https://www.tzlonglivedmetal.com