The water pump is one of the important components of the automobile engine cooling system. The function of the water pump is to pressurize the coolant to ensure that it circulates in the cooling system and accelerates the heat dissipation. As a long-term operating device, the water pump will also malfunction during use. How to troubleshoot these failures? Many people will find that such inspections are very complicated and the failures are reported directly. Actually, there are some minor fault owners completely. Can be solved, do not need to spend money. If the water pump fails or is damaged during use, the following inspections and repairs may be made.
1. Check the pump body and pulley for wear and damage, and replace if necessary. Check whether the water pump shaft is bent, the degree of wear of the journal, and the shaft end thread are damaged. Check whether the blade on the impeller is broken and whether the shaft hole wears seriously. Check the degree of wear of water seals and bakelite washers. Replace them if they exceed the usage limits. Check the bearing's wear condition. You can use the watch to measure the clearance of the bearing. If it exceeds 0.10mm, replace the new bearing.
2. After the water pump is taken out, it can be decomposed in order. After the decomposition, the parts should be cleaned and checked one by one to see if there are defects such as cracks, damage, and wear. If there are serious defects, they should be replaced.
3. Repair of water seals and seats: If the water seal is grooved, it can be grinded with an emery cloth and it should be replaced if it has worn out; if the water seal seat has rough scratches, it can be repaired with a plane reamer or on a lathe. Replace the new water seal assembly when overhauling.
4. Welding repair is allowed on the pump body with the following damage: length is within 3Omm, does not extend into the crack of the bearing seat hole; the flange joint with the cylinder head has a broken part; the oil seal seat hole is damaged. The bend of the water pump shaft must not exceed 0.05mm, otherwise it should be replaced. Impeller blade damage should be replaced. The water pump shaft hole wear should be replaced or repaired.
5. Check whether the bearing of the water pump rotates flexibly or with abnormal noise. If there is any problem with the bearing, it should be replaced.
6. After the water pump is assembled, rotate it by hand. There is no seizure of the pump shaft and the impeller and the pump housing are not rubbed. Then check the pump displacement. If there is a problem, check the cause and remove it. If the pump fails, the coolant will not reach the corresponding place and its performance will not be effectively exerted, thus affecting the working conditions of the engine. Therefore, the inspection of the water pump must be strengthened
This tag: self-priming pump, diaphragm pumps, sewage pumps, centrifugal pumps, magnetic pumps, vacuum pumps, http: //.
Trapezoidal Toothed PU Timing Belt
Industrial synchronous belt applies the superior synthetic neoprene imported
from Japan as main raw material. It matches with multiple auxiliary materials with
various uses. Skeleton uses the superior glass fiber cord imported from japan. Tooth
face of the belt adopts nylon 66 high spandex for protection.
Synchronous belt drive is a novel drive mode that utilizes pulley gear meshing to
transfer motive power. It has accurate synchronous drive function. It needs no
lubrication without slip differential nor pollution and with little noise. Drive efficiency
reaches to 0.98. Speed ratio range can fulfill 1:10. Allowable linear speed can attain
50m/s. Drive efficiency ranges from several hundred watts to several kilowatts. It
suits multi-axial drive. It features as fine dynamic flex resistance, good anti-cracking
properties, superior ozone-proof performanca, sound heat-resistance and wearability etc.
Trapezoidal Toothed Pu Timing Belt,Belt Conveyor,Synchronous Belt,Stainless Steel Conveyor Belt
Jiangsu Bailite Transmission Technology Co., Ltd , https://www.bailitebelt.com